Opportunity

SAM #FA446027Q0004

Air Force Roof Snow and Ice Retention System for Building 618

Buyer

Fa4460 19 Cons Pka

Posted

November 20, 2026

Respond By

November 27, 2026

Identifier

FA446027Q0004

NAICS

332322

The Department of the Air Force is seeking a complete roof snow and ice retention system for Building 618 at Little Rock Air Force Base. - Government buyer: Department of the Air Force, Air Mobility Command, 19th Contracting Squadron, Little Rock Air Force Base. - Scope: Provide at least 720 linear feet of continuous snow and ice retention coverage for a vertical standing-seam metal roof. - System requirements: Use non-penetrating stainless-steel seam clamps, aluminum rails, and aluminum ice stoppers; include thermal expansion capability and a project-specific layout and bill of materials. - Notable performance requirement: Document clamp capacity of at least 1,500 pounds. No OEM, vendor, or part number is specified. - Requested components: 120 rail sections, 600 seam clamps, 1,200 set screws, 960 ice stoppers, 750 self-drilling fasteners, 120 expansion splices, and 15 installation bits.

Description

This acquisition is a new requirement for the procurement of an engineered, continuous pipe or fence-style rail snow retention system for facility roof installation. 

System Configuration: Must be a continuous horizontal pipe- or fence-style rail snow retention system capable of bridging across structural roof panels and providing continuous longitudinal perimeter retention.   Retention Capacity & Coverage: System must furnish 720 linear feet of continuous perimeter retention coverage.   Substrate Compatibility: Mounting clamps and hardware must be fully compatible with the host metal roofing profile (e.g., standing seam or exposed fastener). Attachment systems for standing-seam profiles must utilize non-penetrating clamping mechanisms to preserve the weather-tight integrity and manufacturer warranty of the roof panels.   Structural Performance Thresholds:   System components (brackets, clamps, rails, and fasteners) must be engineered and rated to resist site-specific snowpack and ice accumulation shear loads without permanent mechanical deflection.   Clamp-to-seam holding strength must meet or exceed minimum structural thresholds (e.g., capable of sustaining design loads up to 500 lbs per clamp or linear foot minimum, adjusted to site-specific engineering design calculations).   Fastening hardware must utilize round-point or non-cutting setscrew designs (e.g., 300-series stainless steel per ASTM F880) to prevent piercing, galling, or compromising protective coatings on metal roof seams.

View original listing