Opportunity

SAM #36C24727Q0119

Getinge VT-3050 Tunnel Washer with Removal and Installation Services

Buyer

VANCO 7

Posted

November 19, 2026

Respond By

November 30, 2026

Identifier

36C24727Q0119

NAICS

339112

The Department of Veterans Affairs is seeking a Getinge tunnel washer and associated installation services for the Atlanta VA Medical Center Veterinary Medical Unit. - Government buyer: Department of Veterans Affairs, Atlanta VA Medical Center – Veterinary Medical Unit; Network Contracting Office 7 is identified in the notice. - OEM: Getinge; the SOW names the Getinge VT-3050 tunnel washer, part number VT-3050. - Equipment: One washer, with a 30-inch conveyor belt, intended to replace unreliable existing equipment supporting research operations. Listed exterior dimensions are 53 inches wide by 83 inches high by 26 inches deep; the unit is factory-assembled and tested but shipped disassembled for entry. - Fit and safety requirements: The notice specifies a 49-by-78-inch wall opening, while the SOW specifies a 48-by-84-inch doorway; this difference should be verified. The washer must fit the existing footprint, and the wall-to-machine interface must avoid gaps that could create biohazard or cross-contamination risks. Narrower belts or shorter wash chambers are unacceptable. - Included services: Inland freight; removal and disposal of the existing washer; final utility connections within five linear feet of the equipment connection points; delivery, unloading, on-site transport, leveling, assembly, startup, and one operator/supervisor training session.

Description

Please view the SOW attached.

Submit documentation with description for considerations of products.

Tunnel washer:

Facility infrastructure constraints limit replacement equipment to the footprint of the existing tunnel washer. Restricted wall opening dimensions of 49" wide x 78" tall dictate the maximum equipment size. Requires a non-standard 30" conveyor belt tunnel washer because a standard 36" conveyor belt unit cannot fit through the existing opening. Smaller-than-30" conveyor belts or shorter wash chambers are unacceptable due to operational and safety concerns. Maintaining a proper wall-to-machine interface is critical to prevent gaps between the washer and wall opening. Gaps would create biohazard risks, allowing potential cross-contamination between dirty and clean areas.

View original listing