SAM #FA3016PartsWasherCleaner

Provision and Maintenance of Recirculating Parts Washers for U.S. Air Force at Joint Base San Antonio

The U.S. Air Force, through the 802d Civil Engineering Squadron at Joint Base San Antonio, is seeking a contractor to provide and maintain recirculating parts washers across multiple base locations. - Government Buyer: - U.S. Air Force, 802d Civil Engineering Squadron (802 CES)/CEIEC, Joint Base San Antonio - Products Requested: - Recirculating parts washers using Mil-PRF-680 Type II solvent - Multiple models specified: Model 14 (5 Gal), Model 30 (15 Gal), Model 34 (24.5 Gal), Model 81 (80 Gal), IT40MP (28 Gal), IT48M6 (48 Gal), IT48M4 (42 Gal), IT48 (42 Gal), MRC32 LPM1 (unknown capacity), IT200 Paint Gun Clnr (unknown capacity) - Total quantities: Model 14 (2), Model 30 (9), Model 34 (6), Model 81 (2), IT40MP (6), IT48M6 (1), IT48M4 (2), IT48 (2), MRC32 LPM1 (2), IT200 Paint Gun Clnr (1) - Services Requested: - Installation, monthly or bi-monthly maintenance, and reporting for parts washers - Provision of manufacturer cut-sheets, Safety Data Sheets, and bi-monthly solvent usage reports - Unique Requirements: - Solvent recycling and waste minimization practices - Lighting and filtration to maintain solvent effectiveness - Permanent labeling with operating procedures to minimize emissions - Minimum freeboard ratio of 0.70 for immersion cleaners - Compliance with environmental and safety regulations - No specific OEMs are named, but models suggest industry-standard equipment; competitors likely include Safety-Kleen, CRC Industries, and similar manufacturers.

Description

The contractor shall provide all necessary equipment, tools, materials, transportation and labor to provide and maintain recirculating parts washers using solvent recycling and waste minimization practices.

Recirculating parts washers shall include lighting and filtration to maintain solvent effectiveness between service intervals. It shall also have a permanent and conspicuous label posted on or near the parts washer or immersion cleaner summarizing proper operating procedures to minimize emissions. All immersion cleaners shall have a minimum freeboard ratio of 0.70, when the width is measured at the solvent surface level

View original listing