SAM #12444026Q0126

Truck Bed Upgrade for 2026 Chevrolet 3500 HD – OEM Removal and CM Truck Bed Installation

This procurement opportunity is for a truck bed upgrade on a 2026 Chevrolet 3500 HD (Single Rear Wheel) for the USDA Forest Service, Oconee Ranger District, Georgia. - Government Buyer: - Agency: USDA Forest Service - Sub-agency: Oconee Ranger District - Office: Chattahoochee-Oconee National Forest - OEMs Involved: - Chevrolet (vehicle manufacturer) - CM Truck Beds (replacement bed manufacturer) - Vendors: No specific resellers or integrators named; open to qualified small businesses - Products/Services Requested: - Removal of the factory-installed OEM pickup bed from a 2026 Chevrolet 3500 HD - Installation of a CM Truck Bed, Model 8'6/84/54/42 (quantity: 1) - Integration of electrical systems, lighting, sensors, and fuel filler components - Quality check and testing to ensure compliance with DOT requirements - Documentation of all work performed - Unique/Notable Requirements: - Contractor must safely disconnect all electrical and auxiliary connections - Removal and installation must avoid damage to the vehicle - Installation must follow manufacturer specifications and industry standards - All work must be documented and approved by the government - Adherence to safety protocols and DOT compliance is mandatory - Set aside for small businesses, including 8(a) and EDWOSB

Description

*see attachments

Statement of Work (SOW) 2026 Chevrolet 3500 HD (Single Rear Wheel) OEM Bed Removal and Installation of CM Truck Bed – Model 8'6/84/54/42

1. Vehicle Information • Make/Model: 2026 Chevrolet 3500 HD • Configuration: Single Rear Wheel • Current Condition: Equipped with factory‑installed OEM pickup bed and back up camera on factory installed bed • VIN: 1GC4KSEY1TF291258

2. Contractor Responsibilities The contractor shall perform the following:

A. Removal of Factory Bed • Safely disconnect all electrical, back up camera, sensors, fuel filler, and auxiliary connections tied to the OEM pickup bed. • Remove factory bed without damage to the truck frame, chassis wiring, or components. • Inspect and clean mounting points on the frame after bed removal.

B. Preparation for Upfit • Verify chassis measurements and mounting compatibility for CM model 8'6/84/54/42. • Ensure all wiring harnesses, lighting connectors, and fuel filler components are positioned for proper integration with the new bed. • Provide any necessary mounting hardware if not included by the manufacturer.

C. Installation of CM Truck Bed (Model 8'6/84/54/42) • Properly mount and secure the CM bed to manufacturer specifications and torque requirements. • Align and install fuel filler neck, rear lighting, license plate lighting, and reverse sensors (if applicable). • Connect and test all electrical systems including brake lights, turn signals, reverse lights, and marker lights. • Ensure the bed sits level, securely fastened, and free of vibration or interference with vehicle components.

D. Quality Check and Testing • Perform full inspection confirming structural security, proper alignment, and correct electrical function. • Test vehicle lighting and safety systems to ensure compliance with DOT requirements. • Verify proper clearance between bed, tires, frame, and suspension components.

3. Deliverables • Completed removal of OEM bed • Fully installed CM Truck Bed (Model 8'6/84/54/42) • Documentation of all work performed 4. Schedule • Work to begin on: 8/1/26 • Estimated completion: 8-12 weeks

5. Acceptance Criteria The installation will be considered complete when: • CM bed is mounted to manufacturer specifications • All electrical and safety systems function correctly • No fault codes or warning indicators are present • Vehicle passes final inspection by the government/agency representative

6. Additional Requirements • Contractor must follow all safety protocols and industry standards. • Any changes, unexpected issues, or additional parts required must be approved before proceeding.

View original listing