SAM #FA301626Q0142

Procurement and Installation of Two Commercial Garage Doors at JBSA Lackland

This opportunity involves the procurement and installation of two large commercial garage doors at Joint Base San Antonio (JBSA) Lackland, managed by the 502d Contracting Squadron under the U.S. Air Force. - Government Buyer: - U.S. Air Force, 502d Contracting Squadron (502 CONS/PKBD), Joint Base San Antonio Lackland - OEMs and Vendors: - Cornell Iron Works (specified as the model for the doors) - Brand-name equivalents to Cornell Iron Works ESD10 are acceptable - Products/Services Requested: - Two (2) interior coil weathered service garage doors, 20 ft x 20 ft, 22-gauge galvanized steel curtain, standard gray factory finish, extruded mill-finish aluminum bottom bar with astragal, lintel brush seal, single-guide weathering, motor operation with photo-eye safety sensors, 20 PSF wind load rating - Electrical installation including dedicated 120V/20A circuits, disconnects, hardwiring, conduit for control switches and motion sensors, and all necessary control wiring - 3-year warranty on both parts and labor - Unique/Notable Requirements: - Brand-name or equal to Cornell Iron Works Model ESD10 - All work must be completed within 45 calendar days of contract award - Project is a 100% small business set-aside - Installation must occur during normal duty hours at Building 5077, JBSA Lackland - Award will be made on a Lowest Price Technically Acceptable (LPTA) basis

Description

This is a 100% Small Business Set-Aside RFQ for the procurement, installation, and electrical integration of two (2) 20’ x 20’ Cornell Iron Works Model ESD10 (or brand-name equivalent) interior coil weathered service doors at Building 2079, JBSA Lackland. The required door specifications include a 22-gauge galvanized steel curtain, standard gray factory finish, extruded mill-finish aluminum bottom bar with astragal, lintel brush seal, single-guide weathering, motor operation with photo-eye safety sensors, and a 20 PSF wind load rating. The contractor is responsible for installing a dedicated 120-Volt, 20-Amp circuit to each motor, setting and hardwiring a disconnect at each motor, piping conduit for the control switches and motion sensors, and pulling all necessary control wiring. Additionally, a comprehensive 3-year warranty on both parts and labor is required for this project.

Interested vendors shall respond to this Solicitation IAW the attached documents and instructions to offerors.

Site Visit will be held at 09:00 am CDT on Monday 13 July 2026, at 1875 Arizona St, Lackland Air Force Base, TX 78236.

JBSA-Lackland requires a valid Base Pass and Identification to enter. Anyone who does not have the necessary identification to enter the base must send an email (NLT 10 days prior to site visit) to both CS and CO (see POC above) requesting DoD SAFE Drop to submit an Unescorted Access Request(UAR JBSA LAK ) (Attachment 2). It is your responsibility to confirm that the base access request has been received by 502 CONS. For additional information, please contact the CS and CO.

Refer to each attachment for additional details and Addendum to RFO 52.212-1 Instructions to Offerors— Commercial Products and Commercial Services, for specific Proposal Preparation and Format Instructions.

All questions must be submitted in writing through email no later than 16 July 2026 at 12:00 p.m CDT.

Responses to questions will be posted by the Government on the SAM.gov, contracting opportunities website as received. Questions submitted after this date/time will not be considered. Please respond to this RFQ by emailing your response to: Joyce Yeboah at joyce.yeboah.gh@us.af.mil and Thomas Farrell at Thomas.Farrell.5@us.af.mil, no later than 12:00pm CDT, 27 July 2026 in order to be considered timely.

View original listing