SAM #FA500026Q0025

Hangar Roof Replacement at JBER, Alaska

This opportunity from the Department of the Air Force seeks contractors for a major roof repair and replacement project at Joint Base Elmendorf-Richardson (JBER), Alaska. - Government Buyer: - Department of Defense, Department of the Air Force, Pacific Air Forces, 673 CONS LGC - Scope of Work: - Remove existing built-up roof (BUR) from both the barrel center section and east side roof low section of Hangar Building 11525 - Install new 3-ply SBS-Modified BUR roof assembly with granular cap sheet on the barrel roof section - Install new 90-mil EPDM roof assembly on the south lower roof low section - All roofing assemblies must be fully adhered - Replace roof drains, flashings, vent pipe flashing, cover board (as required), vapor barrier, cant strips, metal copings, and trim with new materials - Products/Services Requested: - SBS-Modified BUR roof assembly (3-ply, granular cap sheet) - 90-mil EPDM roof assembly - Associated roofing components (drains, flashings, vapor barrier, etc.) - Unique/Notable Requirements: - No specific OEMs, brands, or part numbers are specified - All materials and assemblies must meet full adhesion requirements - Work is to be performed at a secure military installation (JBER) - OEMs and Vendors: - No specific OEMs or vendors are named in the solicitation

Description

Site visit is scheduled for 8 June, 2026, at 12:00PM. Building 11525 is a one-story, 113,000 square feet (SF) building framed from steel and cast concrete (beams and columns with CMU infill). The building was originally constructed in the early 1940s and is a historic property. The high barrel roof section that?s approximately 200-ft (curved) by 280-ft, two low roof low sections that are approximately 35-ft by 280-ft each, and one low roof section that approximately 62 ft by 242 ft. This project will remove the existing built-up roof (BUR) from both barrel center section and the east side roof low section identified in Sheets AD-101 and A-101, down to the existing decking and replaced with new 3-ply SBS-Modified BUR roof assembly with granular cap sheet on the barrel roof section and the south lower roof low section shall be replaced with a new 90-mil Ethylene Propylene Diene Monomer (EPDM) roof assembly. All roofing assemblies shall be fully adhered. Replace existing roof drains, flashings, vent pipe flashing, cover board (as required), vapor barrier, cant strips, metal copings and trim with new. Additional Links:Department of Defense Procurement ToolboxPIEE Solicitation Module Link for FA500026Q0025Registration Instructions for the PIEE Solicitation ModuleWeb Based Training for the PIEE Solicitation Module

View original listing